Posts Tagged ‘Home Repair’

How To Make A Combo Of Garbage Disposal Unit And A Dishwasher ?

Sunday, May 16th, 2010

It is not a difficult job to fit a garbage disposal unit in kitchen sink. There is no doubt that assembling its parts and checking it for no leaks is a time consuming exercise. And if we have a dishwasher, it will enhance the labor and time taken because dishwasher is emptied into the waste pipe. But with the fitting of the garbage disposal unit, the dishwasher is emptied in the garbage disposal.

Fortunately, attaching a garbage disposal to a dishwasher is easy. The article below familiarizes the homeowners with the steps to connect the garbage disposal with the dishwasher.

To begin this process we shall first of all clean the bottom of the sink cabinet and keep a bucket beneath the sink. Using a pipe wrench, loosen the pipe and remove it. Any water in the pipe may be disposed in the bucket. Remove the drain pipe by unscrewing the long screws that joins the sink and the drain pipe.

Use a small putty knife to trim away the old plumber’s putty that helped seal the drain inside the sink, and lift the drain pipe out of the sink.

Place a 1/4″ bead of plumber’s putty around the drain opening in the sink. Drop the new sink flange into the drain opening and press it into place. From under the sink, slide the fiber gasket and backup ring onto the sleeve. Hold these pieces in place. Next slip on the mounting ring and snap ring.

Align the disposer with the three mounting ears on the sink mounting assembly. Holding the disposer in place, turn the lower mounting ring until all three mounting ears are locked into the mounting assembly.

Bringing the mounting and the disposal in line, slightly turn the unit and it will tighten and get locked with a click sound. The wall drain pipe can then be connected with the unit and using the J-trap supplied by the manufacturer.

Plug the disposal plug into the outlet under the sink and press the red reset button on the underside of the disposal to set the system for use. Turn the water on at the sink and check for leaks. Operate the electrical switch above the sink to activate the disposal and make sure it turns on. Be sure the water is still running when you do this or it may damage the unit.

Scott Rodgers is a fine author who has been providing great guidance on plumbing works all over USA. His exemplary knowledge has, in fact, sparked significant rise in revenue for talented plumbers across the nation, from Lawrenceville Plumbers to Belleair Beach Plumbers .

Chem-dry Top Portland Carpet Cleaning Service

Monday, January 11th, 2010

Portland, Oregon is probably one of the leading “green” cities in the United States, so it does not surprise anyone that they would even be thinking “green” when it comes to Portland carpet cleaning services. There is one service that stands out for being 100% “green” and that would be Chem-Dry.

A 100% guarantee of truly environmentally safe cleaning comes with the service of this Portland carpet cleaning service. The promise that all that they do to your carpet is not just safe for the environment but also safe for your family and pets.

For the customer, this carpet cleaning service is a worry free service. They promise the customer that by using their service there will be no threat of bacteria growth or mold growth.

A lot of issues come up after a person uses a carpet cleaning service, issues they probably would expect to come from getting their carpet cleaned. With this carpet cleaning service they promise that there will be no bacteria, no mold growth, there will be no detergent residue left behind, old stains will not reappear after a short time of cleaning, no harsh chemical smells, no allergic reactions or water flooding under the furniture.

The benefits of using this Portland carpet cleaning are numerous and all environmentally safe. They ensure that they will use only “green” environmentally safe products, it dries in a short two hour span, they remove virtually all stains no matter how bad they are, trusted in the community for twenty years, dealing with those who are certified and experienced technicians, next day service is available, 100% satisfaction guaranteed and they are backed by the Rug and Carpet Institute.

The reason why the carpet cleans so rapidly with this Portland carpet cleaning service is because they don’t use any of the traditional soaps and chemicals that other companies may use. Instead they use a technique they call carbonating bubbles. This procedure actually helps the drying process by not leaving standing water on the carpets.

If you have ever used club soda to remove a stain from something small, then you are already aware of the power of the carbonation in this soda. With the same principle this Portland carpet cleaning service utilizes the power of carbonation bubbles to deeply clean your carpet. The carbonation actually lifts all the dirt, dust and allergens that are in your carpet to the surface for easy removal thereafter.

To this day, people probably still think that the only way to really get a carpet clean is to flood it with lots of water and detergents or harsh chemicals. Thinking that by soaking the carpet this way it will dissolve the dirt, but; instead all it does is push the dirt deeper into the carpet and leaves way for the water to soak into the padding of the carpet. From there the water can become a breeding ground for mold and bacteria. But by using this Portland carpet cleaning service you can avoid that because; the carbonating bubbles actually make the dirt and dust rise to the surface of the carpet, not only thoroughly cleaning the carpet in a “green” fashion but also lessening the possibility of spots reappearing and any growth of mold and/or bacteria is inhibited.

Portland Carpet Cleaners offers cleaning for carpet, rugs, and upholstery of any type. 15% off at our website! Visit now!

How To Install Under- Cabinet Puck Lights ?

Monday, January 11th, 2010

Deficient light in the kitchen makes the work not only boring but difficult. Improper light on the kitchen counter tops often seems to be a big problem when you are unable to even make out your doings. The way to solve this problem is to mount lighting to the underside of overhead cabinets.

Puck lights are therefore the best option to light up the counter tops of the kitchen. Puck lights are generally small and circular in shape and are mounted in the housing. Apart from providing bountiful light over the kitchen counters, these are a great way to enhance the beauty and grace to the kitchen.

If someone feels like installing these unique lighting fixtures then, following steps would surely help you out. Since, it is simply a do- it- yourself, you don’t need to rush to look for an electrician. Only thing you need is to gather some tools and equipments that you would be needing while installing the under-cabinet puck lights. Like for example, screwdriver, pencil and a wire cutter.

Deciding the place to locate the lights would be the first step here. Puck lights are usually installed in a string. Ensure, they are placed at equal distances and also, the gap between two lights should be around 12 to 18 inches.

In order to accurately place in the lighting fixtures, it is better to first mark the location with the pencil. The only thing that needs care and attention is, putting the puck lights right in the middle of the counter or the shelf. This is because, uniformity plays a vital role in under- cabinet lights.

Done with all the markings, now you are ready to put- in place the puck light housing. Hosing is basically a frame that holds the light. Safely install them. Also, fasten them with the nuts and bolts that are provided in the light kit. A small opening under the housing for wiring purpose should be unseen and covered.

Measure the distance from one light to another and between the power source to the first light to determine the length of your wiring. Cut the wires accordingly. Since, the puck lights are connected in series, these are operated using a single power source.

Put in the lights in the housing and then, check your installation by plugging in the electrical cord in the outlet. Since, it is dangerous to work with the live electricity, better turn off the main supply before doing any electrical job.

Scott Rodgers has been excelling with roofing works for a long time now. His commendable guidance has generated business opportunities for many Crescent Roofers (Need one? click here!) and Dupont Roofers (Need one? click here!).

The Experts At Montgomery Plumbing

Monday, January 11th, 2010

Montgomery Plumbing is a plumbing company found in the heart of Montgomery, Alabama. They present all existing plumbing services and also declare that they are open at any time in case of disaster. They urge you to get in touch with them immediately in order to prevent further damage after emergency plumbing problems come up. Your safety and health are also special considerations for us when a plumbing crisis occurs.

This plumbing company can be reached by phone or by Internet any time of the day or night. Their website offers a 10% discount when you contact them online.

The wide variety of services that Montgomery Plumbing offers range anywhere from leaks and drain trouble to septic tanks and even water appliance repair. They offer services for both residential and commercial plumbing needs. These services include, but are not limited to the following: rust and corrosion, fittings, rusty water heaters, repairing traps, general maintenance, water pump needs, toilet problems and dishwasher and water heater repair.

They can do plumbing inspections and preventative maintenance. This can solve a potential problem before it happens.

Experts can also do a broad range of plumbing services that relate to remodeling, including bathroom and/or kitchen add-ons or remodels. If you are having pipeline or blueprint problems, they can reconfigure and offer solutions. Plumbers can attach drain waste vent pipes, replace or fix sinks, and set up your washer and dryer. They also understand area building codes, removing a large part of your remodeling stress and giving you some peace of mind.

Expert plumbers can handle a minor leak, a massive disaster, a scheduled examination, and even a premeditated job. They have a very competent group of plumbers to look after every possible plumbing requirement. They can be spoken to anytime for emergency plumbing predicaments.

The skilled pros at Montgomery Plumbing are ready to lend a hand with small leaks, catastrophes, routine inspections, and your planned projects. Their team is ready to handle all plumbing needs, so contact them for whatever you need done, large or small, day or night. Plumbing services can be frustrating, dangerous, gross, and even exasperating (or all at the same time), so it is nice to know that someone is available to meet your needs as they arise.

Plumber in Montgomery Companies Supply Contractors is affordable and dependable check out our website for details. See The Plumbing Blog for local plumbing news.

Why Water Heater Maintenance Is Essential ?

Sunday, January 10th, 2010

When you take a water heater you do not need to concern about its working as it will work by its own, but yes one important thing of concern is to maintain your water heater. Maintenance is very essential in order to maintain the efficiency and life of a water heater. Here we will discuss various steps needed to maintain your water heater but before that let’s see some basic problems occurring in the water heater.

The major problem that comes in a water heater after some time is corrosion. Keeping this thing in mind, water heaters are provided with an anode rod that protects the tank by pulling all the corrosive elements towards it. If this rod gets damaged, your water heater could go in big trouble.

The water that goes into water heater is contaminated with sediment and dust to some extent. Over a period of time, the sediment gets settled down at the bottom of the tank and lowers the efficiency of the burner. This causes more consumption of electricity by the heater. The accumulation of sediment at the bottom of the tank also gives birth to bacteria which in turn makes water smelly. There are many more problems that occur in a water heater, we will now find the solutions for these problems.

To maintain your water heater, the most important step is to inspect the anode rod twice in a year or more depending on how corrosive your water is. It can be removed from the top of the water heater. Before removing the rod, turn off the cold water inlet valve. If the anode looks like a worn wire then it means anode is required to be replaced.

Bottom of your tank has a lot of accumulated sediment. To remove that, you need to regularly flush your tank. For doing this you can connect a garden hose to the drain valve located at the bottom of the tank. After this, open the valve and allow the water to flow for several minutes. Be careful because the water coming out will be very hot.

Dip tube helps in connecting cold water supply to the water heater. A problem or damage in this pipe results in passage of cold water through shower heads or faucets. Hence, in such scenario, replace the dip tube with a fresh and new dip tube. Keep in mind that while replacing, you need to cut down the water supply.

The valves for maintaining the temperature and pressure (TP&R) in water heater need to be checked once in six month or so. You can check it by raising or lowering down the test lever. Periodic checking of it can reduce the leakage to a great extent.

Thermostat controls the water temperature. It also needs a periodic examination as a fault in thermostat can prove to be very dangerous for you. If thermostat can not read the right temperature of heater, the temperature of heater could go very high. To tackle these situations, call an experienced professional.

Scott Rodgers is a noted author who has been providing ample guidance on plumbing works all over the country. His luxurious knowledge has, in fact, sparked significant rise in revenue for talented plumbers across the nation, from East Norwich Plumbers to Glen Head Plumbers .